Underground Metal Detector, Deep Depth Long Range Metal Detector
1. Detection depth range:5-50m
2. Detection distan cerange :100-1000m
3. Rechargeable battery:8 hours of continuous work
5. Thtemperaure range:45℃ to 85℃
6. Humidity:0~95%(non condensing)
7. 16 bit processor speed,40MIPS –16MHz
8. 32 bit DSS synthesis chip,wave from output
9. Digital frequency synthesisX20PLL,automatic frequency
10. Color LCD display,a resolution of 480 x 320 pixels
11. Net weight:6.6kg,Gross weight:10.5kg
12. Product size:47X37X13.5cm
Scanner control installation
Note: Before the daily operation, the battery must be fully
charged! If you do not charge it, the EPX10000 might go wrong. If
abnormal , this may be the first time warning that the battery
power is too low and must be charged. If the battery power is
charged a whole night, after that, the battery is still no power,
you need to replace the battery or charger, or AC power outlet
without electricity. If the battery is charged,but it is not full
of power,you may need to replace the built-in battery. A new fully
charged battery can let EPX10000 continue to work about eight
Before turning on the scanner, put the EPX10000 transmitter on the
ground, the sensor antenna is connected to the corresponding jacks
of the transmitter. When open the transmitter,never plug the
sensor, if doing it, it will cause damage to the machine.
Previously used EPX10000 scan,first make all the necessary
1. The sensor is connected to the scanner testing (+) testing (-)
on the jack, insert the probe of sensor on the earth
2. The transmit antenna signal transmission is mounted on the
3. with the power key is turned "On / Off” knob, turn on the power.
At this time, in the LCD area, power indicator,horizontal
trmming,longitudinal trmming indicator lights.
4. at this time, EPX10000 is scanning all selected element . Before
starting the detection process, please let it work 3-5 minutes,
which will be briefly explained later.
5. after the end of the operation, remember to turn off EPX10000.
For ease to use,the instrument requires the use of a smll battery
charger is connected to the power line charg instrument.
Receiver - The rotary switch on the top of the receiver panel are
the headphone and the antenna jack. When do not use, do not connect
the antenna rods with the receiver! If the antenna rod is saved
with it inserted in the receiver , it will cause the battery to
Receiving antenna rod - rod antenna is designed to point out to the
operator that he / she has entered a power transmission line
between the sensor and the target. Under normal circumstances, the
operator should hand held the antenna rod stably and balanced, as
high as your waist, and slightly in front of the operator. When
hand held the antenna rods, rod antenna should is pointed to the
front and parallel to each other and separated by 8-18 inches away.
Everyone needs to find their own best distance. It takes trial and
error to find. Please remember, the people who operate this device,
calm relaxed person will do better than the tense stiff! When you
enter the RF energy line, measured metal,the antenna rod will
And the radar scan pointer will stop in one location. When the
antenna and radar cross and the scanner pause, you see the dawn of
victory would come.
Edited by Johnny